2
« Last post by modellius on September 29, 2024, 05:31:20 PM »
When I started this project I knew this will be hard, and so it is.... At first leg I cut the fuselage to make it accurate, after I made the jet exhaust place as a guide line for the rest, it turns out the rear end of the fuselage is more sculpting than modeling... First I made the base shape from Evergreen styreen and then come the putty, a lot of it...... While I'm make the layers of putty and sanding I'm trying to figure out how to make the rear '' bar '' section, but first in the in the meantime I will start the jet engine intake