Let Let Let - Warplanes > Miscellaneous Subjects
C.S.S. David
Ernie:
I though I would post this here, please forgive me if this is out of place. As I mentioned in my introduction I like to build different types of models, and I also like to try to sample kits from different manufactures. This is the C.S.S. David, a torpedo boat from the American Civil War. It is a kind of interesting subject, and the kit is made by Cottage Industry Models. It is resin and white metal. As the real boat was not painted, this will be a good exercise in painting wood grain. If it is not out of place, and you guys are interested in seeing how it goes, I would like to build it, if it does not fit, that is okay too.
C.S.S. David
C.S.S. David
Ernie
No.1:
This is so good choice mate :-ok Hope you will have time to keep this progress build, this is so interesting. Thanks to the cottage industry many interesting subject could be find. One question- what kind of protection was used in that time for wood? I think wood used on water.
Sall:
Uuuuhhhhh... This is sooo interesting!! I would like to see more. Go forward mateeee!! :-tri
Ernie:
Thank you guys. No.1, as far as I can tell, no protection against the water was used, the hull was made of Oak and the seams between each plank were most likely caulked with tar, the water would have caused the planks to swell, helping to seal the seams. I do not know what the builders thought the life span of the vessel would have been either. At this point many of these creations were experiments, this one was built in the back yard of the designer! It did prove successful enough that depending upon the source that you use for reference between 4 and 50 more were built; I tend to think 50 is a bit much, and the number built were much lower. Plus the others were lumped together and generically called David's after the original, making it a bit more confusing to determine the actually number, and even the original from later copies. Interestingly, many people refer to this as a submarine, and while it does look like one, it was made to ride low on the water and was open on the top, so it could not submerge ( well it could, but only once :) ).
This is one reason I like kits from small manufactures, there are so many different subjects available, and often a lot of modelers pass them by.
Ernie
No.1:
Nico info mate :) One old and effective method used by manufactured was cooking wax with oil of turpentine and then hot brushed over surface. In the joint was used thin rope which is deep into that solution or something similar and push inside with small hammers. But it is possible in the rush that no protection was used, they are simply delivered for fast actions. Design is very nice for that time.
Navigation
[0] Message Index
[#] Next page
Go to full version