Thank you friends !
The fuselage is over complicated, the rear sections two halves are bottom and top, the front is left and right side, even the nose section is two parts.......Probably for manufacturer's easier mold of different variants..... A lot of putty will be needed as I can see......However, I started on engine and intakes, it's a disaster, pin marks, nothing similar to the real thing. The front blades of the engine are provided in the box, but after mounting it in the fuselage they are too low, so cutting, adding are done to put them in to right position. The intakes are junk, a lot of pin marks, missing areas and its all visible, they are big so all of these needed a correction, also there are some missing parts in the intake which are not provided by Hobby Boss and Eduard as well so more scratchbuild to come. And due to large intakes I will need to figure out some sort of intake tunnels between the intake parts and engine blades......Back to the cockpit, there is a missing part also, above the front instrument panel, even Eduard has not given them, and in the rear it was a gap which I filled with styreene sheets ..... Fun and games have been started indeed.... The last two pis are from britmodeler.com to show you the missing parts
