I've forgotten a little trapdoor!
Same technique of course...
![](http://users.skynet.be/bk320910/rodenspad052.JPG)
I've also begun the work on the louves of the part going under the motor. Not really easy. And the part is not yet correctly formed...
![](http://users.skynet.be/bk320910/rodenspad053.JPG)
The build of the radiator will be fun too...
![](http://users.skynet.be/bk320910/rodenspad054.JPG)
One hour was needed to prepare those tiny things...
![](http://users.skynet.be/bk320910/rodenspad055.JPG)
Total: 130 (65 of each). Following the instructions from PART, only 49 of each seem to be needed. I will check my doc to verify if there are other possible places for use.
I've used Klir (equivalent of future) to glue the little parts.
![](http://users.skynet.be/bk320910/rodenspad056.JPG)
Klir, water, toothpicks, and a 3/0 brush (not on the photo)
With the brush, I put a little drop of Klir on the place of the part
![](http://users.skynet.be/bk320910/rodenspad057.JPG)
The part is placed with an humidified toothpick
![](http://users.skynet.be/bk320910/rodenspad058.JPG)
A drop of klir again, to "secure" the work... Then, placement of the last element of the ensemble
![](http://users.skynet.be/bk320910/rodenspad059.JPG)
And here is the final result:
![](http://users.skynet.be/bk320910/rodenspad060.JPG)
Not an easy work to do. Nerviously it was hard... So, the second panel of the engine cover will be made next time.
I have finished with another drop of Klir on all the elements.